Related Manuals for Measuretek ES-H Series
Summary of Contents for Measuretek ES-H Series
- Page 1 W W W . M E A S U R E T E K . N E T E E E E S S S S - - - - H H H H series series series series User/Technical Manual Contents subject to change without notice Version 1.0 07/2017...
-
Page 2: Table Of Contents
CONTENTS CONTENTS CONTENTS CONTENTS 1. 1. 1. 1. INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION ........................1 General and Safety Information General and Safety Information General and Safety Information General and Safety Information ..........................1 Sp Sp Sp Specifications ecifications ................................1 ecifications ecifications 2. -
Page 3: Introduction Introduction
Maximum capacity + 9d Safe Overload Capacity Safe Overload Capacity Square pan; Platter Dimensions (L x W) Platter Dimensions (L x W) Round pan; dia. 120mm Platter Dimensions (L x W) Platter Dimensions (L x W) Size: 140x140mm ES-H www.measuretek.net... -
Page 4: Unpacking And Setup Unpacking And Setup
3. 3. 3. 3. OVERVIEW OF OVERVIEW OF CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS OVERVIEW OF OVERVIEW OF CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS 3.1 Controls Controls Controls Controls Weighing Platter Display Window Leveling Bubble RS232 Interface AC Adapter Receptacle Push Buttons ES-H www.measuretek.net... -
Page 5: Front Display 3.2 Front Display
Short Press: (in weighing mode) Turn on or turn off the backlight Short Press: (In counting & calibration Goes to next item of current sub-menu MODE mode) Short Press: (in weighing mode) Change weighing unit of measure UNIT ES-H www.measuretek.net... -
Page 6: Operations Operations
Sample unit weight should not be less than 1division (0. 0. 0. 0.1g). Sample unit weight should not be less than 1division ( 1g). Sample unit weight should not be less than 1division ( Sample unit weight should not be less than 1division ( 1g). 1g). ES-H www.measuretek.net... -
Page 7: Backlight Function
6.2 Data form output by ES series electronic balances + (-) XXX. XX UNIT< CR> Note: Note: All the segments above belong to ASC ASC Ⅱ Ⅱ Ⅱ Ⅱ . Of these, the unit can be set by ES-H series electronic balances. Note: Note: 6.3 Wiring method:... -
Page 8: Troubleshooting
TARE”. TARE TARE Incorrect Weight Balance was not set to zero. Then weighing can be done. Reading Balance has not been correctly calibrated. Recalibrate the balance. Calibration Procedure Incorrect weights being used Use correct weights. does not work ES-H www.measuretek.net...
Need help?
Do you have a question about the ES-H Series and is the answer not in the manual?
Questions and answers