Related Manuals for Measuretek EHW-EM-03
Summary of Contents for Measuretek EHW-EM-03
- Page 1 EHW-EM User/Technical Manual Contents subject to change without notice Version 1.0 07/2017...
-
Page 2: Table Of Contents
CONTENTS INTRODUCTION ........................1 General and Safety Information ..........................1 Specifications ................................1 Unpacking and Setup ......................2 Contents ................................. 2 OVERVIEW OF CONTROLS AND FUNCTIONS .................. 2 3.1 Front Display ..............................2 3.2 Indicator Display Character Definitions ........................3 3.3 Key Functions .............................. -
Page 3: Introduction
Electronic scales are precision instruments. Do not operate near cell phones, radios, computers or other electronic devices that emit radio frequencies that may cause unstable readings. Specifications Model EHW-EM-03 EHW-EM-06 EHW-EM-15 Max. Capacity 3 kg (6 lb) -
Page 4: Unpacking And Setup
2. Unpacking and Setup Remove the scale from the box and place it on a firm, level surface. Avoid locations with rapid temperature changes, excessive dust, moisture, air currents, vibrations, electromagnetic fields, heat or direct sunlight. Adjust the leveling feet until the bubble is centered in the circle of the level indicator (located on the front panel). -
Page 5: Indicator Display Character Definitions
3.2 Indicator Display Character Definitions EHW‐EM ... -
Page 6: Key Functions
3.3 Key Functions Functions Button Short Press: (when off) Power on the scale (when on) Sets display to zero Long Press: (when on) Power off the scale Short Press: Tare a weight Long Press: Switch between unit of measure EHW‐EM ... -
Page 7: Operations
4. OPERATIONS 4.1 Power on / Power off scale Place the scale on a flat, stable surface. Level the scale using the leveling bubble at the lower left side of the display. With the weighing platter empty, press the ON/OFF/ZERO key to power on the scale. The self-check will run, show the x. -
Page 8: Calibration
5. Calibration 1. Prepare standard weights, and make the scale with no load. 2. When the scale is off, press and hold down TARE/UNIT button, and then press ON/OFF/ZERO button at the same CAL-0 time till appears. Release the two buttons. 3. -
Page 9: Troubleshooting
9. Troubleshooting 9.1 Troubleshooting SYMPTOM PROBABLE CAUSE REMEDY Check power cord connections. Make sure Power cord not plugged in or properly power cord is plugged into the power outlet. Will not power on connected. Power outlet not supplying electricity. Check power source. Replace batteries. Or Battery discharged.
Need help?
Do you have a question about the EHW-EM-03 and is the answer not in the manual?
Questions and answers