SPH Engineering SkyHub User Manual page 14

4 • Preparation
Prerequisites
Required desktop software:
• UgCS v5.3.0 or higher
• UgCS Custom Payload Monitor v4.1.0
• WinSCP
Required desktop software for DJI drones:
• DJI Assistant 2 for Enterprise (M300, M350)
Required mobile software for DJI drones:
• DJI Pilot 2 (referred below as DJI Pilot)
• UgCS Companion
Connect to SkyHub Using Wi-Fi
Important: It is strongly recommended to switch on a remote controller before any
operations with the SkyHub Wi-Fi.
After powering on the SkyHub operates as Wi-Fi access point with following credentials:
• SSID: UgCS-SkyHub-****** (where ****** is the SkyHub serial number)
• Passphrase: 12341234
Note: Windows users might be suggested to enter PIN the first time. Please, switch to security
key mode before entering the passphrase.
Figure 4.1 — Windows Wi-Fi connection dialog. PIN mode
Copyright © 2019—2025, SPH Engineering
4 • Preparation
(referred below as UgCS)
(referred below as UgCS-CPM)
14
SkyHub User Manual
Revision 14 • December 2024