Kwikset SMARTCODE 955 Installation And User Manual page 3

7
Add user codes
Move swiftly during programming. If no digit is pressed for 10 seconds, the system will time out and you will need to restart the procedure.
A
Make sure the door is open.
Press and release the Program button using the SmartKey™
tool or a paper clip. You will hear two beeps.
Program
button
D
Enter a User Code. It must be between 4 and 8 digits.
For security reasons, the
must be unique. For example,
you are unable to program a
user code
user code
8
OPTIONAL: Enable / Disable Programming Code
A
A Programming Code enables you to
make changes without needing to
access the Program button. This is ideal
for landlords to allow programming
from the outside, without access to the
interior Program button.
Please note that once a Programming
Code is enabled, the Program button
is disabled and can be used only to
factory reset the lock.
E
Enter a Programming Code. It must be
between 4 and 8 digits.
The Programming Code cannot
be the same as any user code.
Test the lock and review lock functionality
9
Unlocking the Door with a User Code
previous step can unlock the door.
Enter user code.
The lock will beep
twice to indicate
that it unlocked.
Tip: You can press
the Kwikset button
before entering
your user code
to light up the
keypad at night.
Emergency Egress
The interior lever of this lock will always open the door when turned, regardless of whether it is locked
or unlocked. This is to allow for a safe and easy exit in case of emergency.
B
1
Press
E
Kwikset
Press
as well as a
.
B
Make sure the door is open. If you have
not enabled a Programming Code,
press and release the Program button
using the SmartKey™ tool or a paper
clip. You will hear two beeps.
If you have enabled a Programming
Code, enter your Programming Code,
Kwikset
then press . You will hear one
green.
Program
button
F
Kwikset
Press .
Unlocking the Door with a Key
a b
To unlock using a key,
turn the key clockwise
to the horizontal
position then turn the
lever to open the door.
. You will hear one short beep and
.
C
3
Press . You will hear one short beep
G
Re-enter Programming Code.
Turnpiece Functions - Choosing a Mode
To remove the key, turn
Auto-lock mode
the key back to the
vertical position.
Vertical
Key or code is needed for
entry from the outside.
Re-key the lock (if needed)
1 IMPORTANT: Remove lever before re-keying.
a b
c d
3 / 4
C
Kwikset
Press .
F
You will hear one long beep and
successful. If you hear three beeps
unsuccessful. Repeat from step A.
D
Kwikset
Press .
H
Kwikset
Press . You will hear one
green if successful. If you hear three
was unsuccessful. Repeat from step A.
Passage mode
or
Lock will Lock will
beep once beep twice
Horizontal
when when
turnpiece turnpiece
is turned is turned to
to vertical horizontal
position. position.
Stays unlocked, allowing entry
without a key or code.
2 Re -key the lock to work with your
existing key. See the supplied
SmartKey™ Re-key instructions for
more information.