Table of Contents
Advertisement
ZIP DRIVE JUMPERS
The three-position jumper block for the Zip drive is located
on the rear of the drive. The following description applies
when the rear of the drive is viewed with the IDE connector
to the left of the jumper block, and the power connector to
the right.
T
Drive 0 Select (Master Drive Select) — right two pin
sets jumpered
T
Drive 1 Select (Slave Drive Select) — right-most pin set
jumpered
T
Cable Sect Mode — all three pin sets jumpered.
TAPE BACKUP UNIT JUMPERS
T
Cable Select jumper
T
Master device (5,6)
T
Slave device (3,4)
6-16 Setting Jumpers
(1,2) Not used
Enabled, DS jumpered
Disabled, DS open (factory default)
Disabled, open (factory default)
Enabled, jumpered.
Advertisement
Table of Contents
