Advertisement
Quick Links
Single Monitor Stand with
Overhead Monitor Stand
Assembly Guide
IMPORTANT: As there are different versions of each rig depending on your
region, please ensure that you are using the correct instruction set. The
part number below should match the part number labeled on your box
MS-FM-QD2
Published 2024-6-26
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for TRAK RACER MS-FM-QD2
Summary of Contents for TRAK RACER MS-FM-QD2
- Page 1 Assembly Guide IMPORTANT: As there are different versions of each rig depending on your region, please ensure that you are using the correct instruction set. The part number below should match the part number labeled on your box MS-FM-QD2 Published 2024-6-26...
- Page 2 TABLE OF CONTENTS Symbol Legend Part list Assembly Notes Assembly Instructions...
- Page 3 IMPORTANT: As there are different versions of each rig depending on your region, please ensure that you are using the correct instruction set. The part number below should match the part number labeled on your box IMPORTANT: Due to the nature of cut aluminium profile, some metal shavings may still be present after our extensive QA cleaning process.
-
Page 4: Part Lists
PART LISTS tooltip tooltip tooltip MS-FM-SIN6 TR80-4M4 TR80-TMARM5 NOTE: Some screws and washers are pre-installed. These will be part of the parts list and will need to be loosened and reattached according to the instructions. tooltip tooltip M8X16mm Ball Bearing Nut Hex Screw Lock Washer Flat Screw... - Page 5 NOTE TOP SIDE tooltip INSIDE OUTSIDE FRONT SIDE INSTALLATION ORDER FOR SCREWS & WASHERS HOW TO MEASURE SCREWS ① SCREW ② LOCK WASHER ③ WASHER (IF APPLICABLE) FLAT SCREW HEX SCREW BUTTON SCREW If you have any issues, please contact us at support@trakracer.com...
- Page 6 NOTE T-NUTS It is strongly advised that spring T-Nuts are inserted by sliding from the ends of profiles. Please take careful note of each step of all T-nuts as some are to be installed in anticipation of future steps. If T-Nuts are skipped, and the ends are no longer accessible, they can be inserted by “rocking”...
- Page 7 SH-M8-16 NS-M8 tooltip M8x16mm tooltip tooltip Slide ‘B’ to the position Remove End cap and slide First. ‘C’ in each side first Slide ‘B’ to the position Slide ‘B’ to the position First. First. tooltip tooltip WF-M8 WL-M8 SH-M8-20 M8x20mm...
- Page 8 WF-M8 WL-M8 SH-M8-20 NS-M8 tooltip M8x20mm tooltip tooltip IMPORTANT: If your monitor screws are under 8mm (M8), you will need to use washers (not supplied) tooltip...
- Page 9 FINISHED...
Need help?
Do you have a question about the MS-FM-QD2 and is the answer not in the manual?
Questions and answers