Advertisement
Quick Links
Single Monitor Stand with
Overhead Monitor Stand
Assembly Guide
tooltip
IMPORTANT: As there are different versions of each rig depending on your
region, please ensure that you are using the correct instruction set. The
part number below should match the part number labeled on your box
MS-FM-SIN-TR2
Published 2024-6-26
1
Advertisement
Related Manuals for TRAK RACER MS-FM-SIN-TR2
Summary of Contents for TRAK RACER MS-FM-SIN-TR2
- Page 1 IMPORTANT: As there are different versions of each rig depending on your region, please ensure that you are using the correct instruction set. The part number below should match the part number labeled on your box MS-FM-SIN-TR2 Published 2024-6-26...
- Page 2 TABLE OF CONTENTS Symbol Legend Part List Assembly Notes Assembly Instructions...
- Page 3 IMPORTANT: As there are different versions of each rig depending on your region, please ensure that you are using the correct instruction set. The part number below should match the part number labeled on your box IMPORTANT: Due to the nature of cut aluminium profile, some metal shavings may still be present after our extensive QA cleaning process.
-
Page 4: Part Lists
PART LISTS tooltip tooltip MS-CM-SIN6 TR80-TMARM6 NOTE: Some screws and washers are pre-installed. These will be part of the parts list and will need to be loosened and reattached according to the instructions. tooltip M8X20mm Ball Bearing Nut Hex Screw Lock Washer Flat Screw WL-M8... - Page 5 NOTE TOP SIDE tooltip OUTSIDE INSIDE FRONT SIDE INSTALLATION ORDER FOR SCREWS & WASHERS HOW TO MEASURE SCREWS ① SCREW ② LOCK WASHER ③ WASHER (IF APPLICABLE) FLAT SCREW HEX SCREW BUTTON SCREW If you have any issues, please contact us at support@trakracer.com...
- Page 6 NOTE T-NUTS It is strongly advised that spring T-Nuts are inserted by sliding from the ends of profiles. Please take careful note of each step of all T-nuts as some are to be installed in anticipation of future steps. If T-Nuts are skipped, and the ends are no longer accessible, they can be inserted by “rocking”...
- Page 7 tooltip WF-M8 WL-M8 SH-M8-20 NS-M8 tooltip M8x20mm Remove End cap and slide ‘D’ in each side first tooltip IMPORTANT: If your monitor screws are under 8mm (M8), you will need to use washers (not supplied) tooltip...
- Page 8 FINISHED...
Need help?
Do you have a question about the MS-FM-SIN-TR2 and is the answer not in the manual?
Questions and answers