Basic Calls & Phone Use
Making basic calls
You make a simple call in the same way as you would with a normal phone, except that you need to press
STD code and the phone number. To make international calls, you must first enter the international dialling code (see page 13).
Starting a call
Key in the phone number. Check the number on the display.
Press
to send the call.
To abort the call at any time, press
When the call is sent, the screen displays the number called or the name stored in the phonebook (if a name has been stored in memory
along with the number - see page 27) and a connection graphic or a CLI picture that has been allocated to the number called (see
page 33).
Correcting mistakes
Use the
and
keys to scroll through the number, then press CLR to clear individual digits or hold down CLR to completely clear a
phone number.
Ending calls
Press
briefly or close your phone. The phone returns to standby.
Receiving calls
When someone calls your number, the Ring tone will sound (if set - see page 18), LED will flash, and the phone number of the caller
may be displayed if the calling line identification facility is available and the caller has activated the feature. If the caller's phone number
has been stored in your phonebook along with a name and a CLI picture (see page 33), that name and picture will be displayed. If the
caller has withheld their identity, the screen will give a message that the received number is being withheld.
6
briefly.
O
Use the full STD area code even if
you are in the same town. If the
after entering the area
numbers are too long to be
displayed within one line, excess
part is deleted and '...' is added at
its end.
O
The Main LCD display shows the
strength of the radio signal that
links your phone to the network.
A maximum signal is shown by 4
shaded blocks and a minimum
signal by 1 block.
O
If
will turn off.
is held down, your phone