Basic Calls & Phone Use; Making Basic Calls; Correcting Mistakes; Ending A Call - NEC N401i User Manual

a PIN code when it is turned on. If this is the case, enter your code with the phone's keypad. If you insert a SIM card other than your own, information
such as call logs may be lost. (See "Security (M17)" on page 24 for details.)
Basic Calls & Phone Use

Making basic calls

You make a simple call in the same way as you would with a normal phone, except that you need to press
Dialling (STD) code and the phone number. To make international calls, you must first enter the international dialling code (see page 13).
Use the full STD area code even if you are calling to a person in the same town. If the numbers are too long to be displayed within one line, after
pressing , excess part is deleted and '...' is added at its end.
The main-LCD display shows the strength of the radio signal that links your phone to the network. The maximum signal strength is shown by 4 shaded
blocks and the minimum signal strength by 1 block.
Starting a call
☛
Key in the phone number. Check the number on the display
☛
Before the other party answers the call, you can end the call by pressing
headset, you can also end the call by pressing and holding the button on it.
When the call is sent, the screen displays the number called or the name stored in the phonebook and a connection graphic or a Calling Line Identification
(CLI) picture that has been allocated to the number called (see page 53).

Correcting mistakes

Use the and to move the cursor and then press CLR to clear individual digits, or hold down CLR to completely clear a phone number.

Ending a call

☛
While talking, press
If is held down, your phone will turn off.
When you use the headset, you can also end a call by pressing and holding the button on it.
You cannot end a call by closing your phone when the headset is connected.

Receiving an incoming call

When someone calls your number, the ringer will play (if set - see page 22), the LED glows in the specified colour, and the phone number of the caller
may be displayed if the calling line identification facility is available and the caller has activated the feature. If the caller's phone number has been related
briefly or close your phone. The phone returns to the standby screen.
➔
or SK1 to send the input number to start the call
briefly, pressing SK2 or closing your phone. When you use the
after entering the area Subscriber Trunk
5