Displaying Lldp Information; Displaying Lldp Neighbor Information; Table 13: System Capabilities - SMC Networks SMCGS10C-SMART Management Manual

| Monitoring the Switch
C 5
HAPTER

Displaying LLDP Information

D LLDP I
ISPLAYING
D LLDP
ISPLAYING
N
EIGHBOR
I
NFORMATION
NFORMATION
Use the monitor pages for LLDP to display information advertised by LLDP
neighbors and statistics on LLDP control frames.
Use the LLDP Neighbor Information page to display information about
devices connected directly to the switch's ports which are advertising
information through LLDP.
P
ATH
Monitor, LLDP, Neighbors
P
ARAMETERS
These parameters are displayed:
Local Port – The local port to which a remote LLDP-capable device is
◆
attached.
Chassis ID – An octet string indicating the specific identifier for the
◆
particular chassis in this system.
Remote Port ID – A string that contains the specific identifier for the
◆
port from which this LLDPDU was transmitted.
◆ System Name – A string that indicates the system's assigned name.
Port Description – A string that indicates the port's description. If RFC
◆
2863 is implemented, the ifDescr object should be used for this field.
System Capabilities – The capabilities that define the primary
◆
function(s) of the system as shown in the following table:

Table 13: System Capabilities

ID Basis
Other
Repeater
Bridge
WLAN Access Point
Router
Telephone
DOCSIS cable
device
Station only
When a capability is enabled, the capability is followed by (+). If the
capability is disabled, the capability is followed by (-).
– 240 –
Reference
–
IETF RFC 2108
IETF RFC 2674
IEEE 802.11 MIB
IETF RFC 1812
IETF RFC 2011
IETF RFC 2669 and IETF RFC 2670
IETF RFC 2011