SMC Networks SMCGS10C-SMART Management Manual page 182

| Configuring the Switch
C 4
HAPTER
Quality of Service
Ingress Classify – Specifies the classification method:
◆
Disable – No Ingress DSCP Classification is performed.
■
DSCP=0 – Classify if incoming DSCP is 0.
■
Selected – Classify only selected DSCP for which classification is
■
enabled in DSCP Translation table (see
All – Classify all DSCP.
■
Egress Rewrite – Configures port egress rewriting of DSCP values:
◆
Disable – Egress rewriting is not performed.
■
Enable – Egress rewriting is performed without remapping.
■
Remap DP Aware – Frame with DSCP from analyzer is remapped
■
and remarked with the remapped DSCP value. Depending on the
frame's DP level, the remapped DSCP value is either taken from the
DSCP Translation table, Egress Remap DP0 or DP1 field (see
page 184).
Remap DP Unaware – Frame with DSCP from analyzer is
■
remapped and remarked with the remapped DSCP value. The
remapped DSCP value is always taken from the DSCP Translation
table, Egress Remap DP0 field (see
W I
EB NTERFACE
To configure ingress translation and classification settings and egress re-
writing of DSCP values:
Click Configuration, QoS, Port DSCP.
1.
Set the required ingress translation and egress re-writing parameters.
2.
Click Save.
3.
– 182 –
page 184).
page 184).