Configuring Voip Traffic - SMC Networks SMCGS10C-SMART Management Manual

Web smart 10-port ge switch
Hide thumbs Also See for SMCGS10C-SMART:
Table of Contents

Advertisement

member the Voice VLAN. Alternatively, switch ports can be manually
configured.
Use the Voice VLAN Configuration page to configure the switch for VoIP
C
V
IP
ONFIGURING
O
traffic. First enable automatic detection of VoIP devices attached to the
T
RAFFIC
switch ports, then set the Voice VLAN ID for the network. The Voice VLAN
aging time can also be set to remove a port from the Voice VLAN when
VoIP traffic is no longer received on the port.
P
ATH
Configuration, Voice VLAN, Configuration
P
ARAMETERS
These parameters are displayed:
Global Configuration
Port Configuration
3.
Mode
– Enables or disables Voice VLAN operation on the switch.
3
(Default: Disabled)
VLAN ID – Sets the Voice VLAN ID for the network. Only one Voice
VLAN is supported on the switch. (Range: 1-4095; Default: 1000)
The Voice VLAN cannot be the same as that defined for any other
function on the switch, such as the management VLAN (see
IPv4 Address" on page
Registration" on page
130), or the native VLAN assigned to any port
(see
"Configuring VLAN Attributes for Port Members" on page
Aging Time – The time after which a port is removed from the Voice
VLAN when VoIP traffic is no longer received on the port. (Range: 10-
10,000,000 seconds; Default: 86400 seconds)
Traffic Class – Defines a service priority for traffic on the Voice VLAN.
The priority of any received VoIP packet is overwritten with the new
priority when the Voice VLAN feature is active on a port. (Range: 0-7;
Default: 7)
The switch provides eight priority queues for each port. For information
on how these queues are used, see
on page
175.
Mode – Specifies if the port will be added to the Voice VLAN.
(Default: Disabled)
Disabled – The Voice VLAN feature is disabled on the port. The port
will not detect VoIP traffic or be added to the Voice VLAN.
MSTP must be disabled before the Voice VLAN is enabled (see
Settings for STA" on page
118), or the Voice VLAN port mode is set to Auto or Forced.
This prevents the spanning tree's ingress filter from dropping VoIP traffic tagged for the
Voice VLAN.
– 169 –
C
HAPTER
42), the MVR VLAN (see
"Configuring Egress Port Scheduler"
| Configuring the Switch
4
Managing VoIP Traffic
"Setting an
"Multicast VLAN
159).
"Configuring Global

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents