Toto GLORIA TX492SGC Installation

SPECIFICATIONS
150±10
20
G½
WALL
420
Ø250
50
0
67
-4
OPERATING CONDITIONS
1. 1.
Water supply pressure : 0.05 ~ 0.75 MPa. Water supply pressure : 0.05 ~ 0.75 MPa.
2. 2.
Ensure that water supply is clean ( No Sand, Dirt, Etc.). Ensure that water supply is clean ( No Sand, Dirt, Etc.).
ATTENTION
1. 1. Don't use abrasive cleaners or solvents on faucets and Don't use abrasive cleaners or solvents on faucets and
fittings. fittings.
2. 2. Flow Regulator should not be remove because it could Flow Regulator should not be remove because it could
damage the system damage the system
3. 3. As the product model is constantly updated, the actual As the product model is constantly updated, the actual
product may not look the same as it shown in the diagram, product may not look the same as it shown in the diagram,
but the basic installation principles are the same. but the basic installation principles are the same.
The hot water supply side of the faucets is in a condition of The hot water supply side of the faucets is in a condition of
4. 4.
high temperature. Do not allow skin to contact with the high temperature. Do not allow skin to contact with the
hardware surface directly. Otherwise, scalding may occur. hardware surface directly. Otherwise, scalding may occur.
S06840Z
"GLORIA" CROSS HANDLE SHOWER COLUMN SET TX492SGC
INSTALLATION
1
MOUNT CONNECTORS
PARALLEL WITH THE WALL
Hot Hot
Water Water
Supply Supply
Leg Leg
Use Seal tape
(Not Include)
3
Drill
2 x Ø8
Holes
40
5
Pipe
Cover
Bolt
Hex.
Key
Hanger
Body
2
Cover
Packing
Cold Cold
Water Water
Supply Supply
Nut *
Body
* Tighthen the nut
4
Sleeve Anchor
Bracket
w/ Oring
Screw
*Tighten the nut with wrench.
6
Bolt
Hex.
Key
Holder
Packing
Nut*
Shower
Head
Pipe
Flow Regulator &
Check Valve inside
(Don't remove)
7
Hand Shower
Packing
Flexible Hose
Packing
TROUBLESHOOTING
CHECK CHECK
PROBLEM PROBLEM
POINT POINT
Unsatisfactory spray Unsatisfactory spray 1, 2 1, 2
Water leaks around the nut Water leaks around the nut 3 3
Water leaks around the handle Water leaks around the handle 4 4
5 5
Handle is loose Handle is loose
3. NUT
1. NOZZLES
2. NOZZLES
5. BOLT
MAINTENANCE
All Finishes : Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning
SOLUTION SOLUTION
Clean Clean
Tighten Tighten
Tighten Tighten
Tighten Tighten
Flow Regulator
Inside
(Don't remove)
4. CERAMIC
HEAD WORK
R8