Table of Contents
Advertisement
Remote Management via the Console Port
Configure the Switch Site
Connect the switch's DB9 serial port to the modem's serial port
using standard cabling. For most modems which use a 25-pin port,
you will have to provide an RS-232 cable with a 9-pin connector on
one end and a 25-pin connector on the other end. Set the modem
at the switch's site to force auto-answer mode. The following is a
sample initialization string: "ATQ1S0=1&D0&K0&W" as defined
below:
Q1
: Inhibit result codes to DTE
S0=1 : Auto answer on first ring
D0
: Don't care DTR
K0
: Disables DTE/DCE flow control
W
: Write command to modem memory
Configure the Remote Site
At the remote site, connect the PC's COM port (COM 1~4) to the
modem's serial port. Set terminal emulation type to VT100, specify
the port used by your PC (i.e., COM 1~4), and then set
communications to 8 data bits, 1 stop bit, no parity, 19200 bps and
no flow control.
S
M
WITCH
ANAGEMENT
1-3
Advertisement
Table of Contents
