Pyronix MC1Z2/SHOCK-WE Installation Manual page 12

Shock Sensitivity
The shock has 5 levels of sensitivity, 1
being the lowest and 5 the highest. It also
has the capability if being completely
disabled as well.
Follow these steps to set the sensitivity:
Press and hold the button positioned
at the top left corner of the PCB.
The red LED will ash, pause for a
second, and then ash again.
The number of ashes indicate the
sensitivity level that the device is set
to. After the pause, it will move to the
next level until it reaches 5 ashes.
After 5 ashes, the LED will illuminate
for 2 seconds indicating that the
shock sensor is disabled. If the button
is still pressed, the cycle is restarted
at level 1.
Release the button at the number of
ashes (level) required.
A short press of the button will indicate
the sensitivity level that the device is
currently set to. It will indicate this by
ashing the red LED between 1 and 5
times.
Wiring in a Roller Shutter