Related Manuals for Roborock Qrevo Slim
Summary of Contents for Roborock Qrevo Slim
- Page 1 Roborock Qrevo Slim Robotic Vacuum Cleaner User Manual Read this user manual with diagrams carefully before using this product and store it properly for future reference.
- Page 3 English Français Español...
-
Page 4: Table Of Contents
Contents 05 Safety Information 08 Battery and Charging 08 International Symbols Explanation 09 FCC/IC Statement 10 Product Overview 11 Installation 12 Connecting to the App 12 Instructions for Use 14 Routine Maintenance 16 Basic Parameters 16 Environmental Protection Information 17 Common Issues... -
Page 5: Safety Information
• Do not sit or stand on the robot or dock. • To prevent corrosion or damage, do not use any disinfectant and only use cleaning solution recommended by Roborock. • Do not put any low objects (such as shoes, mats) near raised areas like stairs. Otherwise, the robot may fall down caused by malfunctional sensors. - Page 6 • Always operate the device in well-ventilated areas to prevent overheating. • Roborock disclaims all liability for indirect, incidental, or consequential damages resulting from the use, misuse, or inability to use this product. This disclaimer does not affect any statutory rights that may not be disclaimed under applicable law.
-
Page 7: Grounding Instructions
GROUNDING INSTRUCTIONS This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. -
Page 8: Battery And Charging
Battery and Charging • Do not wipe the charging contacts with wet cloth or wet hands. • If the product is left unused for a long period, store it in a cool, dry place after having it fully charged, unplugged, and switched off. -
Page 9: Fcc/Ic Statement
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Correspondence of the responsible party in USA Company Roborock Technology Co. Address ROOM 1227, 12TH FLOOR, 1000 N. WEST STREET, WILMINGTON, DE 19801 Email... -
Page 10: Product Overview
Product Overview Robot (Bottom View) Mop Cloth Mount A2-1—Cliff Sensors A4-1—Hook and Loop Pads Robot (Top View) A2-2—Carpet Sensor A4-2—Mop Axle A2-3—Side Brush Note: Secure the mop cloths flat in place. —Mop Only/Child Lock A2-4—Optical Flow Sensor • Press to start Mop Only Mop Cloth A2-5—Omnidirectional Wheel •... -
Page 11: Installation
A10-11—Status Indicator Light Notes: make sure that the status indicator light is • When using the robot for the first time, follow it • Breathing: Emptying/Mop washing throughout its whole cleaning route and watch for • Red: Dock error B3-1—More than 0.9 m (2.9 ft) potential problems. -
Page 12: Connecting To The App
(4.9 ft) × 1.5 m (4.9 ft) square area centered reinstalling the tank. on itself. Open the Roborock App, tap the “Add Device” Starting Cleaning or “+” button and add your device following Note: After spot cleaning, the robot will automatically return to the starting point and enter standby mode. - Page 13 Mop Only Child Lock Drying Press and hold to enable/disable the Press to start Mop Only. The main After mop washing or after cleaning, drying child lock. You can also set it in the app. will begin as needed. To manually start or brushes and fan stop operating, and the Once enabled, the robot will not react to stop drying, tap the corresponding button...
-
Page 14: Routine Maintenance
Omnidirectional Wheel Note: After resetting the system, existing settings such brushes. Then, reinstall the hair- as scheduled cleaning and WiFi will be restored to blocking rings, main brush caps, and * Clean as required. factory settings. then main brush bearings. D3-1—Use a tool, such as a small Restoring Factory Settings D1-9—Reinstall the main brushes. -
Page 15: Charging Contacts
Moving the Dock Washable Filter Notes: • The dust bag handle seals the bag on removal to * Clean every 2 weeks and replace every 6-12 months. To move the dock, grip the cord storage prevent leakage. • Always install a dust bag before putting back the dust D6-1—Remove the filter cover and the slot on the back with one hand and the container cover to avoid auto-emptying without the... -
Page 16: Basic Parameters
Environmental Basic Parameters Protection Information Robot Removing the battery Model QC0CRL * The following information applies only when disposing of the robot and should not be followed for day-to-day 14.4 V/5200 mAh (TYP) operations. Battery lithium-ion battery The chemical substances contained in the Rated Input 20 V 1.5A... -
Page 17: Common Issues
• The cleaning tray module or cleaning tray filter is not to WiFi the latest app version and retry. installed or not properly installed. • Unable to connect to WiFi abruptly. There may be an error with your router settings. Contact Roborock customer service for help with troubleshooting. - Page 18 Common Issues Issue Solution Issue Solution • The main brushes or main brush cover is not properly Unable to wash the Reduced emptying • Check that Mop Washing with Hot Water is installed. Check and install in place. mop cloths with hot performance or enabled in the app.
Need help?
Do you have a question about the Qrevo Slim and is the answer not in the manual?
Questions and answers