El.Mo DT2000485 Technical Manual

Technical manual
DT2000485
DT detector with digital PIR sensor, anti-masking
protection and under-crawl function with
ULTRABUS interface for intrusion detection systems
ULTRABUS
advanced serial bus
1 DESCRIPTION
DT2000485 is a dual-technology (infrared and microwave)
detector.
DT2000485 supports connection to ULTRABUS RS-485 se-
rial line.
The detector includes two sections operating in AND or OR
mode.
Infrared section (IR): digital PIR sensor with temperature
compensation and environmental monitoring, multi-focal
lens with white light protection.
An additional bottom lens is used for the under-crawl
function.
Microwave section (MW): 10.525 GHz DRO planar antenna
(also available as an alternative in the 9.9 GHz version). An-
ti-masking and anti-sneak device.
The two green and blue LEDs show the activities of the IR
and MW section respectively.
The red LEDs (only active in case of tampered sensor or tam-
per button open), show the activity of the serial line, either
receiving or transmitting.
DT2000485 can be programmed using the BrowserOne
software.
For side-by-side mounting, differentiated frequencies can
be used.
An optional swivel mount may be used for wall or corner
installation.
DT2000485 is certified IMQ - Security Systems.
Compatible control unit
VIDOMO2K
PREGIO series
PROXIMA series
®
Addressee for this information:
Firmware version
8.3.3.0 or above
2.3.2.0 or above
1.0.2 or above
User | Installer
Compatible control unit
ETRxxx G2 series
TITANIA series
2 PCB
1
2
3
4
1 12V power source terminals and RS-485 connection (A, B)
2 MW antenna
3 PIR sensor
4 Dip switch selectors for addressing
5 RS-485 RX, TX communication LEDs (red)
6 IR LED (green)
7 MW LED (blue)
8 Jumper to exclude protection against removal (S3)
9 Tamper button
1 1 1
Firmware version
1.E or above
4.x or above
9
8
7
6
5