EWM L1.04 - RC XQ Expert 2.0 Rob Operating Instructions Manual page 58

Rectifying faults
Error messages (power source)
Error 20: Low coolant level
Category B
 Low f low rate.
Fill with coolant.

Check coolant f low - remove kinks in the hose package.

Adjust the f low threshold

Clean the cooler.

 The pump does not turn.
Turn the pump shaf t.

 Air in the coolant circuit.
Vent the coolant circuit.

 The hose package is not f illed with coolant.
Switch the machine of f and on > pump running > f illing process.

 Operation with a gas-cooled welding torch.
Deactivate the torch cooling.

Connect the coolant f eed and return with a hose bridge.

Error 22: Excess coolant temperature
Category B
 Coolant is overheating
Allow the switched-on machine to cool.

 Fan is blocked, dirty or f aulty.
Check the f an and clean or replace it.

 Air inlet or outlet is blocked.
Check the air inlet and outlet.

Error 23: Excess temperature
Category A
 External component (e.g. HF ignition units) overheated.
 The power source is overheating.
Allow the switched-on machine to cool.

 Fan is blocked, dirty or f aulty.
Check the f an and clean or replace it.

 Air inlet or outlet is blocked.
Check the air inlet and outlet.

Error 24: Pilot arc ignition error
Category B
 The pilot arc cannot ignite.
Check the welding torch equipment.

Error 25: Forming gas error
Category B
 No gas.
Check the gas supply.

 The pre-pressure is too low.
Remove kinks in the hose package (nominal value: 4-6 bar pre-pressure).

58
[2] .
[2] .
099-00L104-EW501
16.08.2024