EWM L1.04 - RC XQ Expert 2.0 Rob Operating Instructions Manual page 27

5.4.4 System settings
In this area the user can conf igure advanced system settings.
5.4.4.1 Date
Menu item/parameter
Year:
Month:
Day:
Date f ormat:
5.4.4.2 Time
Menu item/parameter
Hour:
Minute:
Time zone (UTC +/-):
Summer time:
Time f ormat:
5.4.4.3 Cooling unit
Switching of f the liquid cooling permanently may cause damage to the welding torch.
Menu item / parameter
Cooling module f ollow-up time [min.]: 1-60 min
Cooling module control:
Temperature error limit
Flow monitoring
Flow error limit
Reset to f actory settings
5.4.4.4 Control
Menu item / parameter
Operation without wire f eeder is possi-
ble
(This parameter controls the system be-
haviour depending on the connected
wire f eeder)
5.4.4.5 Calibration / validation
> see 7.2 chapter selection.
099-00L104-EW501
16.08.2024
Operating the machine control
Value Comment
2014
10
28
DD.MM.YYYY
YYYY.MM.DD
Value Comment
0–24
0–59
-12h to +14h
Yes
No
24 h
12 h AM/PM
Value Comment
Automatic
Permanently
ON
Permanently
OFF
50-80 °C
On
Of f
0.5-2.0 l/min
No
Resets the cooling unit parameters to f actory
Yes
settings.
Value Comment
No (f actory The wire f eeder (WF) can be changed during
setting) operation.
Operation without a connected wire f eeder is
not possible.
The welding system can be operated without a
Yes
wire f eeder connected.
Machine conf iguration (system)
27