EWM L1.04 - RC XQ Expert 2.0 Rob Operating Instructions Manual page 2

Read the operating instructions!
The operating instructions provide an introduction to the safe use of the products.
• Read and observe the operating instructions f or all system components, especially the
saf ety instructions and warning notices!
• Observe the accident prevention regulations and any regional regulations!
• The operating instructions must be kept at the location where the machine is operated.
• Saf ety and warning labels on the machine indicate any possible risks.
Keep these labels clean and legible at all times.
• The machine has been constructed to state-of-the-art standards in line with any applicable
regulations and industrial standards. Only trained personnel may operate, service and re-
pair the machine.
• Technical changes due to further development in machine technology may lead to a dif f er-
ing welding behaviour.
In the event of queries on installation, commissioning, operation or special conditions at the in-
stallation site, or on usage, please contact your sales partner or our customer service department
on +49 2680 181-0.
A list of authorised sales partners can be found at www.ewm -group.com/en/specialist-dealers.
Liability relating to the operation of this equipment is restricted solely to the function of the equipment. No
other f orm of liability, regardless of type, shall be accepted. This exclusion of liability shall be deemed ac-
cepted by the user on commissioning the equipment.
The manuf acturer is unable to monitor whether or not these instructions or the conditions and methods
are observed during installation, operation, usage and maintenance of the equipment.
An incorrectly performed installation can result in material damage and injure persons as a result. For this
reason, we do not accept any responsibility or liability for losses, damages or costs arising from incorrect
installation, improper operation or incorrect usage and maintenance or any actions connect ed to this in
any way.
© EWM GmbH
Dr. Günter-Henle-Strasse 8
56271 Mündersbach Germany
Tel.: +49 2680 181-0, Fax: -244
Email: inf o@ewm-group.com
www.ewm-group.com
The copyright to this document remains the property of the manuf acturer.
Copying, including extracts, only permitted with written approval.
The content of this document has been prepared and reviewed with all reasonable care. The inf ormation
provided is subject to change; errors excepted.
Data security
The user is responsible for backing up data of all changes from the factory setting. The user is liable f or
erased personal settings. The manuf acturer does not assume any liability f or this.
General instructions
WARNING