Subscribe to Our Youtube Channel
Related Manuals for djpower X-SW1800
Summary of Contents for djpower X-SW1800
- Page 2 The information and specifications contained in this User Manual are subject to change without notice. DJPOWER assumes no responsibility or liability for any errors or omissions and reserves the right to revise or to create this manual at any time.
- Page 3 • During heating up and operation, the housing will be scalding hot. Do not touch. • Condensation may form on the bottom of the product, creating damp or wet conditions under and around the machine. Use caution! Surfaces around the product may become slippery. •...
- Page 4 2 INTRODUCTION Description X-SW1800 mini aqua low fog machine creates a continuous spooky low-lying fog hugs the floor and dissipates without rising. By using the Ultrasonic technology, needs for dry ice is eliminated. The main body of the chassis is made of high-strength composite material at one time, with compact size, light weight, good durability and no rust.
- Page 5 Product Overview Product Dimensions - 4 -...
- Page 6 3 TECHNICAL SPECIFICATIONS Input Voltage & Rate 220-240 V, 50/60 Hz Current Limiter Type Breaker AC Power Current Limiter Specifications 8 A, 250 V Total Power Consumption 1,600 W Heating Heat Up Time Appr. 2 min Fluid Tank Capacity Capacity Water Chamber Capacity 7.3 L Adjustable Volume...
- Page 7 Plug the product’s power cord into the power outlet and continue using as recommended. DMX Linking You can link the X-SW1800 to a DMX controller using a 3-pin DMX connection. If using other DMX- compatible products with this product, you can control each individually with a single DMX controller.
- Page 8 4.5.2 Rigging DJPOWER recommends using the following general guidelines when mounting this product. • Before deciding on a location for the product, make sure there is easy access to the product for maintenance and programming purposes.
- Page 9 Press <MENU> repeatedly to switch menu pages. • Press <ENTER> /<STOP> to go back to Standby Page. 5.3.2 Menu Map Parameter Display Description Range X-SW1800 Starting AC-230V 50Hz Pages Heating Up Preparing The machine is heating up. >>>>>>>>>> Page Ready To Work Standby Finished heating up, ready to work.
- Page 10 DJPOWER® X-SW1800 DMX set the starting address in the 001 - 512 DMX range and uses 3 DMX channels, which defines the highest configurable address to 510 to have all channels controllable.
- Page 11 DMX signal is connected, the remote control function is effective. The X-SW1800 can be controlled by w-4 wireless controller. There are two buttons ON the W-4 wireless remote control. Press "ON" button to start the machine and "OFF" button to stop the machine. A machine can receive up to five different coded wireless transmitters.
- Page 12 When the water in the tank is low, the water pump starts to auto refill water. The LCD will flicker and show the warning message as below: Auto refill water X-SW1800 can be supplied with external water tank, the water tank water level must lower than the high of machine. - 11 -...
- Page 13 Run the product in a well-ventilated area until the tank is empty. Do not allow the pump to run dry. Refill with fog fluid to continue using the X-SW1800. Run the machine briefly to clear any cleaning solution from the pump and heater.
Need help?
Do you have a question about the X-SW1800 and is the answer not in the manual?
Questions and answers