Headlight Screening - APRILIA RSV 1000 R FACTORY Manual

To set beam height:
Place the vehicle on the stand, see page
u
58 (PLACING THE VEHICLE ON THE
STAND).
Working from the rear left side of the
u
front fairing, fit a short cross-headed
screwdriver to the adjuster screw (1) and
adjust as follows:
√ TIGHTEN (clockwise) to raise the beam;
√ SLACKEN (anticlockwise) to lower the
beam.
Repeat process for the right beam.
u
104
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
2
When finished:
WARNING
Check for proper beam height setting.
CAUTION
The headlights are also fitted with
adjuster screws (2) for horizontal beam
adjustment.
Correct beam horizontal adjustment is
performed at the factory and we advise
against disturbing standard setting,
unless such adjustment is mandatory in
your country.

HEADLIGHT SCREENING

In case headlights are to be taped (for
using the vehicle on the track), it is
1 r e c o m m e n d e d t o d i s c o n n e c t t h e
connectors of the headlamps to prevent
the lens from overheating because they
are not cooled by air.
S e c u r e a n d i n s u l a t e p r e v i o u s l y
disconnected wires so that they do not
hinder handlebar movement and are
insulated from water.
Restore electric connections before
using the vehicle on the public road.
CAUTION
CAUTION