CHECKING AND CLEANING
THE TERMINALS
Carefully read p. 59 (BATTERY).
◆
Remove the rider saddle, see p. 52 (RE-
MOVING THE RIDER SADDLE).
◆
Make sure that the cable terminals (1)
and the battery terminals (2) are:
√ in good conditions (and not corroded
or covered with deposits);
√ covered with neutral grease or Vase-
line.
use and maintenance RS 50
60
If necessary:
◆
Make sure that the ignition switch is in
position ≈
∆.
◆
Disconnect first the negative (√) and then
the positive cable (+).
◆
Brush with a wire brush to eliminate any
sign of corrosion.
◆
Reconnect first the positive (+) and then
the negative cable (√).
◆
Cover the terminals of the cables and of
the battery with neutral grease or Vase-
line.
REMOVING THE BATTERY
Carefully read p. 59 (BATTERY).
◆
Make sure that the ignition switch is in
position ≈
∆.
◆
Remove the rider saddle, see p. 52 (RE-
MOVING THE RIDER SADDLE).
◆
Release the rubber band (3) from the
couplings (4) and (5) and take it.
◆
Disconnect first the negative (√) and then
the positive cable (+).
◆
Remove the battery breather pipe (6).
◆
Remove the battery from its compart-
ment and put it on a flat surface, in a cool
and dry place.
WARNING
Once it has been removed, the battery
must be stored in a safe place and kept
away from children.