Instructions For Use; Preliminary Checking Operations - APRILIA RS 50 - 2004 Manual

INSTRUCTIONS FOR USE

WARNING
Before departure, always carry out a
preliminary checking of the vehicle to
make sure that it functions correctly
and safely, see the following table (PRE-
LIMINARY CHECKING OPERATIONS).
The non-performance of these checking
operations can cause severe personal
injuries or damages to the vehicle.
Do not hesitate to consult your aprilia
Official Dealer in case there is some-
thing you do not understand about the
functioning of some controls or in case
you suspect or discover some irregular-
ities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.

PRELIMINARY CHECKING OPERATIONS

Component
Front and rear disc Check the functioning, the idle stroke of the control
brakes levers, the fluid level and make sure there are no leaks.
Check the wear of the pads. If necessary, top up the
brake fluid tank.
Accelerator Make sure that it works smoothly and that it is possible
to open and close it completely, in all steering posi-
tions. If necessary, adjust and/or lubricate it.
2 stroke oil/
Check and/or top up if necessary.
transmission oil
Wheel/tyres Check the tyre surface, the inflation pressure, wear
and tear and any damage.
Brake levers Make sure that they work smoothly. If necessary, lubri-
cate the articulations and adjust the stroke.
Steering Make sure that the steering rotates smoothly, without
any clearance or slackening.
Clutch The idle stroke at the end of the clutch lever must be
about 10...15 mm; the clutch must operate without jerk-
ing and/or slipping.
Side stand Make sure that it works smoothly and that the spring
tension brings it back to its normal position.
If necessary, lubricate joints and hinges.
Fastening elements Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
Drive chain Check the slack.
Fuel tank Check the fuel level and top up, if necessary. Make
sure there are no leaks or air bubbles in the circuit.
Coolant With cold engine, visually check if the coolant reaches
the prescribed level.
Lights, warning lights, Check the proper functioning of the acoustic and visual
horn and electric devices.
devices Change the bulbs or intervene in case of failure.
Check
use and maintenance RS 50
Page
22, 23
24, 56
57
25, 44, 45
29
26
√
27
64
√
50, 51
21, 53, 69
28, 29
59...68
31