6 Remove the backplane board:
–
If you are removing a 3.5-inch hard drive (two-drive) backplane, press the release latch at the left end
of the board, slide the board to its right, and lift the backplane off of the securing tabs. See
Figure 3-23.
–
If you are removing a 2.5-inch hard drive (four-drive) backplane, press the release latch at each end of
the backplane and lift the backplane off of the securing tabs. See Figure 6-4.
Figure 3-23. 2.5-Inch Hard Drive Backplane Board Removal and Installation
1
6
5
1
backplane board release latch
4
securing tabs
84
Installing System Components
2
backplane board
5
SAS interface cable
2
3
4
3
securing slots
6
power cable