Dell POWEREDGE 1950 Hardware Owner's Manual page 69

6 Wait 30 seconds for the heat sink to loosen from the processor.
7 Open the other heat sink retention lever.
8 If the heat sink has not separated from the processor, carefully rotate the heat sink in a clockwise, then
counterclockwise, direction until it releases from the processor. Do not pry the heat sink from the
processor.
9 Lift the heat sink off of the processor and set the heat sink upside down so as not to contaminate the
thermal grease.
10 Pull the socket-release lever 90 degrees upward until the processor is released from the socket. See
Figure 3-15.
11 Rotate the processor shield upward and out of the way.
Figure 3-15. Installing and Removing the Processor
2
1
1 socket key (2)
4 processor
12 Lift the processor shield to release the processor, and then lift the processor out of the socket. Leave the
release lever up so that the socket is ready for the new processor.
NOTICE:
Be careful not to bend any of the pins on the LGA socket when removing the processor. Bending the
pins can permanently damage the socket and system board.
3
4
2 notch in processor
5 socket-release lever
6
3 processor shield
6 ZIF socket
Installing System Components
5
69