Figure 3-17. Removing and Installing the Optical Drive Tray
1
optical -drive tray
4
optical drive
Installing the Optical Drive Tray
1 Align the optical drive tray with its opening in the front panel.
The optical drive opening is located directly below the SAS daughter card bay.
2 Slide in the drive tray until the tray snaps into place. See Figure 3-17.
3 Connect the optical-drive cable from the back of the drive. See Figure 3-17.
4 Replace the SAS controller daughter card.See "Installing a SAS Controller Daughter Card or SAS RAID
Controller Daughter Card" on page 56.
5 Close the system. See "Opening and Closing the System" on page 46.
6 Replace the bezel. See "Removing and Replacing the Front Bezel" on page 45.
7 Reconnect your system and peripherals to their electrical outlets, and turn on the system.
74
Installing System Components
1
4
2
optical-drive cable
2
3
3
optical-drive release tab