Dashboard Lighting; Bulbs - APRILIA ETV MILLE CAPONORD - ETV MILLE CAPONORD ABS - 2006 Use And Maintenance Book

10 m 10 m
regulations in force in the country where the
vehicle is used.
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
NOTE
The following information refers
to one unit only, but is valid for both.
◆
Get on the vehicle in riding position, see
p. 46 (GETTING ON AND OFF THE
VEHICLE).
6
For the right part of the headlight (1):
◆
working on the rear right side of the front
part of the fairing, adjust the appropriate
knob (5).
BY TURNING IT CLOCKWISE, you set
the beam downwards.
BY TURNING IT ANTICLOCKWISE, you
set the beam upwards.
For the left part of the headlight (2):
◆
carry out the same adjustment described
before, acting on the knob (6).
After the adjustment:
!
WARNING
Make sure that the vertical adjustment
of the headlight beam is correct.

DASHBOARD LIGHTING

If you need assistance or technical advice,
consult your aprilia Official Dealer, who
can ensure you prompt and accurate
servicing.

BULBS

Carefully read p. 60 (MAINTENANCE).
5
Risk of fire.
K e e p f u e l a n d o t h e r f l a m m a b l e
substances away from the electrical
components.
Before changing a bulb, move the
ignition switch to position "?" and wait
a few minutes, so that the bulb cools
down.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
D O N O T F O R C E T H E E L E C T R I C
CABLES.
NOTE
the fuses, see p. 98 (CHANGING THE
FUSES).
use and maintenance ETV mille Caponord ABS
!
WARNING
!
CAUTION
Before changing a bulb, check
101