ZyXEL Communications P660HW-DX V2 - V3.40 User Manual page 315

802.11g wireless adsl2+ 4-port gateway
Hide thumbs Also See for P660HW-DX V2 - V3.40:
Table of Contents

Advertisement

Table 136 Firewall Commands (continued)
FUNCTION
Delete
P-660HW-Dx v2 User's Guide
COMMAND
config edit firewall set <set
#> rule <rule #> destaddr-
single <ip address>
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask>
config edit firewall set <set
#> rule <rule #> destaddr-
range <start ip address> <end
ip address>
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#>
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#>
config delete firewall e-mail
config delete firewall attack
config delete firewall set
<set #>
Appendix E Firewall Commands
DESCRIPTION
This command sets the rule to have the
ZyXEL Device check for traffic with this
individual destination address.
This command sets a rule to have the ZyXEL
Device check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
This command sets a rule to have the ZyXEL
Device check for traffic going to this range of
addresses.
This command sets a rule to have the ZyXEL
Device check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the ZyXEL
Device check for TCP traffic with a destination
port in this range.
This command sets a rule to have the ZyXEL
Device check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the ZyXEL
Device check for UDP traffic with a
destination port in this range.
This command removes all of the settings for
e-mail alert.
This command resets all of the attack
response settings to their defaults.
This command removes the specified set
from the firewall configuration.
315

Advertisement

Table of Contents
loading

This manual is also suitable for:

P-660hw-d1 v2

Table of Contents