Telnet Login; Figure 117 Remote Management: Telnet; Table 83 Remote Management: Telnet - ZyXEL Communications P660HW-DX V2 - V3.40 User Manual

Chapter 15 Remote Management Configuration

Figure 117 Remote Management: Telnet

The following table describes the labels in this screen.

Table 83 Remote Management: Telnet

LABEL
Port
Access Status
Secured Client
IP
Apply
Cancel

15.5 Telnet Login

Use the following steps to Telnet into your ZyXEL Device's command interpreter.
If your computer is connected to the ZyXEL Device over the Internet, skip to the next step.
Make sure your computer IP address and the ZyXEL Device IP address are on the same
subnet.
3 In Windows, click Start (usually in the bottom left corner) and Run. Then type
and the ZyXEL Device's IP address. For example, enter
default IP address).
4 Click OK. A login screen displays. Enter the password at the prompts.
The default password is 1234. The password is case-sensitive.
206
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
A secured client is a "trusted" computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Click Apply to save your customized settings and exit this screen.
Click Cancel to begin configuring this screen afresh.
telnet
telnet 192.168.1.1
P-660HW-Dx v2 User's Guide
(the