No Security; Table 32 Wireless Lan: General - ZyXEL Communications P660HW-DX V2 - V3.40 User Manual

The following table describes the general wireless LAN labels in this screen.

Table 32 Wireless LAN: General

LABEL
Wireless Setup
Active Wireless
LAN
Network Name
(SSID)
Hide SSID
Channel
Selection
Apply
Cancel
Advanced
Setup
See the rest of this chapter for information on the other labels in this screen.

7.3.1 No Security

Select No Security to allow wireless clients to communicate with the access points without
any data encryption.
If you do not enable any wireless security on your ZyXEL Device, your network
is accessible to any wireless networking device that is within range.
P-660HW-Dx v2 User's Guide
DESCRIPTION
Click the check box to activate wireless LAN.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless client
is associated. Wireless clients associating to the access point (AP) must have the
same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for
the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer
connected to the wireless LAN and you change the ZyXEL
Device's SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must
then change the wireless settings of your computer to
match the ZyXEL Device's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Click Apply to save your changes to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
Click Advanced Setup to display the Wireless Advanced Setup screen and edit
more details of your WLAN setup.
Chapter 7 Wireless LAN
109