Table of Contents
Advertisement
Chapter 17 Bandwidth Management
Figure 94 Management > Bandwidth MGMT > Advanced: User-defined Service Rule
Configuration
The following table describes the labels in this screen
Table 69 Management > Bandwidth MGMT > Advanced: User-defined Service Rule
Configuration
LABEL
BW Budget
Destination
Address
Destination
Subnet Netmask
Destination Port
Source Address
Source Subnet
Netmask
Source Port
Protocol
OK
Cancel
17.9 Bandwidth Management Monitor
Click Management > Bandwidth MGMT > Monitor to open the bandwidth management
Monitor screen. View the bandwidth usage of the WAN configured bandwidth rules. This is
also shown as bandwidth usage over the bandwidth budget for each rule. The gray section of
the bar represents the percentage of unused bandwidth and the blue color represents the
percentage of bandwidth in use.
174
DESCRIPTION
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
Enter the destination IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Enter the port number of the destination. See
common services and port numbers.
Enter the source IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a Source
Address. Refer to the appendices for more information on IP subnetting.
Enter the port number of the source. See
common services and port numbers.
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number.
Click OK to save your customized settings.
Click Cancel to exit this screen without saving.
Appendix F on page 287
Appendix F on page 287
for some
NBG318S User's Guide
for some
Advertisement
Table of Contents
Troubleshooting
