Table of Contents
Advertisement
Figure 89 Management > Static Route > IP Static Route: Static Route Setup
The following table describes the labels in this screen.
Table 61 Management > Static Route > IP Static Route: Static Route Setup
LABEL
Route Name
Active
Private
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Apply
Cancel
NBG318S User's Guide
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete this static
route.
This field allows you to activate/deactivate this static route.
This parameter determines if the NBG318S will include this route to a remote node
in its RIP broadcasts.
Select this check box to keep this route private and not included in RIP
broadcasts. Clear this checkbox to propagate this route to other hosts through RIP
broadcasts.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate neighbor of
your NBG318S that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your NBG318S; over the WAN,
the gateway must be the IP address of one of the Remote Nodes.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Click Apply to save your changes back to the NBG318S.
Click Cancel to return to the previous screen and not save your changes.
Chapter 16 Static Route Screens
165
Advertisement
Table of Contents
Troubleshooting
