OWC Mercury Elite Pro Dual 3-Port Hub Support Manual page 5

2.2 Assembly Options
The OWC Mercury Elite Pro Dual 3-Port Hub offers multiple drive and RAID
configuration options. This device supports 3.5"/ 2.5" SATA HDDs/SSDs.
• (2) SATA HDDs/SSDs configured as a Hardware RAID 0, 1, Independent, or Span.
2.3 Assembly Steps
This section describes the process of installing drives into the OWC Mercury Elite
Pro Dual 3-Port Hub if purchased as an empty enclosure.
1. Begin by placing the device on a static free work surface and remove the two
screws from the back of the enclosure. Store the screws for reassembly. Pull on the front
edge of the enclosure so the inner chassis slides out until fully removed.