OWC Mercury Elite Pro Dual 3-Port Hub Support Manual page 4

G. (1) Kensington Security slot – Attach a Kensington Security lock.
H. (1) DC IN Power Port – Connect the power adapter to power the device.
Getting Started
2.1 Device Setup
This section describes the process of setting up the OWC Mercury Elite Pro Dual
3-Port Hub if purchased with pre-installed drives. The OWC Mercury Elite Pro Dual
3-Port Hub is configured as a Hardware RAID 0 if assembled with (2) SATA or
HDDs/SSDs.
1. Plug the power cable into the OWC Mercury Elite Pro Dual 3-Port Hub DC IN power
port located on the back and into a power outlet. The Power LED will illuminate a solid
white.
2. Connect the included USB cable into the USB 3.2 Gen 2 (10Gb/s) USB Type-C Host
Port located on the back of the OWC Mercury Elite Pro Dual 3-Port Hub and into a
host system. The Power LED will illuminate a solid blue.