EMS FireCell Quick Start Manual page 4

Step 5 - Log on the radio devices
Go to Step 6 if the system has been supplied fully programmed.
The device can now be logged on to the system.
This can be achieved using the log on button or
ident method. The log on button is located inside
the unit.
See FireCell Instruction Pack for more information
Step 6 - Install the devices
Note: When
Sounder Detectors, it is important that
the tamper alignment markers are
properly positioned to ensure correct
operation and to prevent unnecessary
tamper faults.
See FireCell Instruction Pack for more
information.
Step 7 - Program the panel
Note: This step is not necessary if the system has been supplied fully
programmed.
The Hub, RCCs and all radio devices must now be added to the panel ensuring the
loop number and addresses programmed at the FireCell Hub correspond to that
programmed at the panel. This can also be achieved using the Loop Explorer
computer program.
See FireCell Instruction Pack for more information.
©2024 EMS Ltd. All rights reserved
installing Combined
Contact us
Page 4 of 4
PRESS HERE TO
LOG ON
Align tamper
arrows THEN turn
to lock into place
MK140-99 (Issue 7) 18/09/2024 AJM
SERIAL No