Netum Q700 Quick Manual
  1. Manuals
  2. Brands
  3. Netum Manuals
  4. Barcode Reader
  5. Q700
  6. Quick manual

Netum Q700 Quick Manual

Barcode scanning service settings
Hide thumbs Also See for Q700:
1
2
3
4
5
6

Advertisement

Table of Contents

NETUM Q700
Barcode Scanning Service Settings
Quick Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Q700 and is the answer not in the manual?

Questions and answers

Related Manuals for Netum Q700

Summary of Contents for Netum Q700

  • Page 1 NETUM Q700 Barcode Scanning Service Settings Quick Guide...

  • Page 2: Definitions And Terms

    1、Overview 1.1 Definitions and terms Definition/Terms Original Description Turn on the scan module switch and press and hold the scan button on Scan Engine On/Off Scan Engine On/Off both sides of the fuselage to trigger barcode scanning. Out to Cursor Out to Cursor Results of scanned barcode displayed at focus Scan Sound...
  • Page 3 Scan mode:The device has a built-in three-minute scan mode. Select the fast scan mode you are used to. It needs to be turned on and off  to enable the scan. Long-press continuous scan: In this mode, press and hold the scan button to turn on the scan laser, release it to automatically turn off the scan laser, and if the barcode is successfully scanned when the scan button is pressed, the scan laser is turned on repeatedly.

  • Page 4: Add Prefix

    Add custom prefix: add custom characters, numbers, letters, etc. before the barcode output (add "#" for demonstration)  Add a custom suffix: add custom characters, numbers, letters, etc. after the barcode output (add "#" for demonstration)  Add suffix Add prefix 2.1.1Code setting: Configure the barcode parameters of one-dimensional and two-dimensional code.
  • Page 5 2.1.3 Choose code-1d-UPC-A-Enable such as the scan result after scanning "UPC-A" barcode, one less. You can select "UPC-A" type, enable "Check transmit Digit", and scan later the results show normal. Example1:UPC-A barcode:123456789012;When the "Check transmit Digit"not enabled,the result show 12345678901,and when the "Check transmit Digit"...

  • Page 6: More Settings

    2.2 More settings Click "Settings"-"Scan" to slide to the bottom, and click "More". 2.2.1,Check update:Show scan hand type.And can check update after connecting to the internet. Note: "Check update"requires the scanning service version 5.1 or higher. 2.2.2,Custom broadcast:action:This is used to set a custom broadcast. 2.2.3,Custom broadcast barcode:key:This is used to set a custom broadcast content.

Table of Contents