Netum NT-W6 Quick Setup Manual

NT-W6
Quick Setup Guide
This model can work both via USB cable or 2.4G receiver.

Connection Mode

Working via USB cable

Get Started: Connect scanner with your device via USB cable. If you use US keyboard, it's a plug and play
model. If you use other type of keyboard , please refer to below "keyboard language type" to set the
keyboard language before use it. If you use it on MAC system you have to plug a 2.4G receiver working
under wireless mode.

Working via 2.4G receiver

Get Started: Plug the 2.4G receiver on your device, then you can start to use it. (US keyboard by default) If
you use other type of keyboard , please refer to below "keyboard language type" to set the keyboard
language before use it.
Low voltage Alarm: Scanner will make 3x beeps (even you just trigger the button and do not scan any
barcodes) to remind you that it's under low voltage. Please plug the USB cable to charge power for it.
If you want to do other configurations please refer to below programming barcodes.

Firmware Version:

Read below command barcode to check scanner firmware version.
Firmware Version
Below programming barcodes are applied for version - 2.4GWISX_20180412
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and communications
settings. If you need to change these settings, programming is accomplished by scanning the bar codes in
this guide. An asterisk (*) next to an option indicates the default setting.
Important Note: There will not have a beep sound for some of configuration .As long as light turns off a
few seconds before you release the trigger button that means scanner has read the codes successfully.