Setting The Sleep Timer - Aiwa CX-NA31 Operating Instructions Manual

5
6
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps,
If this step is not completed within 4 seconds, repeat from
step 1.
Prepare the source.
To
listen to a CD,
load the disc to be played first on tray 1.
To listen to a
tape,
insert the tape into deck 1 or 2.
To listen to the radio,
tune in to a station.
Press the POWER button to turn the unit off after
adjusting the volume and tone.
O
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source,
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more,
To check the specified time and source
Press the TIMER button while pressing the SHIFT button. The
timer-on time, the selected source name and the duration for
the timer-activated period are displayed for 4 seconds,
To cancel timer standby mode temporarily
Press the TIMER button while pressing the SHIFT button
repeatedly so that 0 or C?)REC disappears on the display.
To restore the timer standby mode, press again to display @ or
@REC.
Using
the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
'Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer,
TIMER RECORDING
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press the TIMER button W while pressing the SHIFT
button so that @REC appears on the display, and press the
I U SET button within 4
seconds. Repeat the steps shown
above from step 2 and insert the tape to be recorded into deck 2
after step 5,
SETTING THE SLEEP TIMER
2
u
The unit can be turned off automatically ,at a specified time.
Use the remote control.
1
2
Press the SLEEP button while pressing the SHIFT
button.
Within 4 seconds, press the ++ or * button ~
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps,
Specified time
To
check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that "SLEEP" on the display disappears,
ENGLISH 20