Connecting An External Ir Receiver To The Dhd Controller; Connecting 12-Volt Trigger Outputs; External Ir Receiver Connection - Runco Video Xtreme VX-44d Owner's Operating Manual

AutoScope Lens Motor (Rear)
Power
AC Input
Switch
3.5-mm
mini plug
Retractable Screen or other Serial No
12-volt trigger-activated
Runco International
Union City, CA
device
Model
OUTPUTS
R/Pr G/Y B/Pb
Video Processor / Controller
H V H/V DVI Out
Figure 3-14. Connecting 12-Volt Trigger Outputs
If infrared signals from the remote control cannot reach the DHD Controller due to
excessive distance or obstructions such as walls or cabinet doors, you can connect an
external IR receiver to the DHD Controller to extend the range of the remote control. See
Figure 3-15.
IR Receiver
Remote
Control
Figure 3-15. External IR Receiver Connection
Runco VX-44d/-55d Owner's Operating Manual
INPUTS
R/Pr G/Y B/Pb H V
Sleeve = Ground
HD1
Tip = +12V
HD2
R/Pr G/Y B/Pb H V
SDI
Pb Pr
DVI 1 DVI 2 Option Component Video
SYSTEM CONTROL INTERFACE
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION:
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
IR
1 2 3
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
S-Video 1
Video S-Video 2 RS-232 Out RS-232 Control
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono
plug)
DHD Controller
Rear Panel
SYSTEM CONTROL INTERFACE
RISK OF ELECTRIC SHOCK
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
1 2 3 IR
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
Y S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Video S-Video 2 RS-232 Out RS-232 Control
CAUTION !
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC
100-230VAC 50-60 Hz, 165 Watts Max
Made In USA
35
CAUTION !
DO NOT OPEN
Made In USA
Connecting an External IR
Receiver to the DHD
Controller
Installation