Picture Select - Pioneer PDP-4304 Operating Instructions Manual

4 Use the 2/3 buttons to select [LOCKED].
C L A M P P O S I T I O N
SET SET
The factory default setting is [AUTO].
Each time you press the 2/3 buttons, the setting
changes as follows:
3 AUTO 2
3 LOCKED 2
5
Press the SET button.
This completes [CLAMP POSITION] setting, and
returns you to the display shown in Step 3.
6
After completing settings, press the MENU button
to return to the normal display.
Notes
÷ [CLAMP POSITION] setting is possible only when INPUT1 or
INPUT5 is selected.
÷ When using this setup, be sure to carefully check the signal
output of the component that you are using. For details, please
refer to the instruction manual supplied with the component
you are connecting.
Setting HDMI (INPUT2)
Perform setting after completing HDMI connection to
INPUT2.
Follow the procedures below and make settings as they
apply to the type of components connected.
Note
HDMI setting is possible only when INPUT2 is selected.

PICTURE SELECT

This function allows you to switch the input signal format
to automatic or manual when inputting the digital signal.
1
Press the MENU button to display the menu screen.
STANDARD
PICTURE SCREEN
:
CONTRAST 0
:
BRIGHTNESS 0
:
COLOR 0
:
TINT 0
:
SHARPNESS 0
:
MPEG NR ON
:
DNR MID
:
CTI ON
:
COLOR TEMP. MID
PICTURE RESET
ENTER
SET
:
LOCKED
MENU EXIT
INPUT2
SETUP OPTION
EXIT
MENU
2 Use the 2/3 buttons to select [SET UP].
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
ENTER
SET
3 Use the 5/∞ buttons to select [HDMI INPUT], then
press the SET button.
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
SET ENTER
4 Use the 5/∞ buttons to select [PICTURE SELECT].
HDMI INPUT
PICTURE SELECT
AUDIO
SET
SET
5 Use the 2/3 buttons to select [PICTURE SELECT]
setting.
The unit has been factory set at the AUTO setting.
Each time you press the 2/3 buttons, the setting
changes as follows:
AUTO
COLOR4 COLOR3
AUTO: Automatically identifies input video signals.
COLOR1: Accepts Y C /P
B B
COLOR2: Accepts Y C /P
B B
COLOR3: Select COLOR3 for too dark or distorted
picture when accepts RGB signals.
COLOR4: Select COLOR4 to remove white glare in the
picture when accepts RGB signals.
Note
Even when AUTO is selected, automatic switching may not occur
properly with some input signals. In this event, select COLOR1,
COLOR2, COLOR3 or COLOR4 manually in accordance with the
actual signal input.
System Settings
INPUT2
SETUP OPTION
:
OFF
:
:
:
EXIT
MENU
INPUT2
SETUP OPTION
:
OFF
:
:
:
MENU EXIT
:
AUTO
:
AUTO
EXIT
MENU
COLOR1
COLOR2
C /P (4 : 2 : 2) signals.
R R
C /P (4 : 4 : 4) signals.
R R
23
EN