Wenger Corporation� Wenger Corporation does not assume any responsibility for any errors that may appear in these instructions� In no event will Wenger Corporation be liable for technical or editorial omissions made herein, nor for direct, indirect, special, incidental, or consequential damages resulting from the use or defect of these instructions�...
Supplied Hardware 2" (50 mm) 3/4" Insert Nut Truss Head Screw Hex Socket Lag Screw 5/8" Wood Dowel Washer Hole Plug Phillips Head Screw * Quantities may vary depending on model *Extra hardware can be discarded Parts List Item Qty Description Item Qty Description Item Qty Description...
Assembly 1� Assemble the base support� Quantities of divider panels, wood dowels and hex head lag screws may vary depending on model� a� With the edge banded surface facing up, insert one wood dowel (16) into the top hole on each end of the three divider panels (15)�...
Page 5
Assembly (continued) 3� Pound two insert nuts (3) into each rear corner of the end panels (2) to make a left-hand and a right-hand side as shown� (Detail C) Detail C 4� Attach caster brackets (1) to the inside corners of the end panels (2) with 3/16"...
Page 6
Assembly (continued) 5� Attach the base support assembly to both end panels (2) using four hex socket lag screws (5) in each from the outside of the end panels as shown� (Detail E) Base Support Assembly Detail E 6� Assemble top cross support� Quantities of wood dowels (16) and hex head lag screws (5) may vary depending on model�...
Assembly (continued) 7� Attach the top cross support assembly to both end panels (2) using three hex head lag screws (5) using the upper set of holes in each side� Top Cross Support Plug the unused holes on both the inside and Assembly outside surfaces using hole plugs (13)�...
Replacement Parts Item Qty Description Item Qty Description Item Qty Description Caster Bracket Locking Caster 12 5/16" Dia Hole Plug Right and Left End Panel Non-locking Caster Top Neck Support Panel Insert Nut 3-6 Brass Hook with Screws 2-5 Divider Panel 3/4"...
Need help?
Do you have a question about the 4-Unit Cello Rack and is the answer not in the manual?
Questions and answers