Wenger Nota Book & Music Storage Rack Assembly Instructions

For wenger nota chairs

ONTENTS

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Note: Please read and understand the Book & Music Storage Rack Assembly Instructions before

attempting installation, assembly, or use.

Note: Remove all items from the shipping containers. Refer to the illustrations on the following pages.

If you need additional information, contact the Wenger Corporation using the information listed

below.

©Wenger Corporation 2006

Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448

Questions? Call.....USA: (800) 733-0393 • International (call collect): (507) 455-4100 • www.wengercorp.com

Book & Music Storage Rack

Printed in USA 12/06

Assembly Instructions

for Wenger Nota™ Chairs

Part #190A064-01

Table of Contents

Need help?

Do you have a question about the Nota Book & Music Storage Rack and is the answer not in the manual?

Page 1 Note: Please read and understand the Book & Music Storage Rack Assembly Instructions before attempting installation, assembly, or use. Note: Remove all items from the shipping containers. Refer to the illustrations on the following pages. If you need additional information, contact the Wenger Corporation using the information listed below. ©Wenger Corporation 2006...
Page 2 This is your sole remedy for breach of this warranty. Should you have a question or problem with any Wenger product, don’t hesitate to call, even if the product is past warranty. It’s important to us that all our customers be satisfied.
Page 3 SSEMBLY 1. Place the Nota Chair upside down on a table or bench covered with a pad or blanket to protect the seat surface. 2. Rotate the Book & Music Storage Rack to insert the two Front Posts all of the way into both of the holes in the inside of the Front Legs.
Page 4 SSEMBLY ONTINUED 3. Rotate the Storage Rack toward the chair and snap the Rear Loops between the Seat and the Back Leg Cross Tube as shown. The Storage Rack must be squeezed together by pushing the back end of the Storage Rack towards the Front Legs to allow the Rear Posts to snap over the Back Leg Cross Tube.