Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Knoll Scope
Summary of Contents for Knoll Scope
- Page 1 Scope Kinked Rail - Installation guide...
- Page 2 Procedure to adjust workstation height using kinked rail kits...
- Page 3 To adjust the height of a top using ‘Kinked rail kits’ follow the *Some diagrams in this document are shown from the underside of the instructions in the fi rst section of this document table. This is to demonstrate the components better. It is not necessary to turn the table over.
- Page 4 Quick Release Clips Top bolts Pull the quick release clips out from the end leg or the intermediate leg. Remove the bolts connecting the kinked rail bracket to the top. (Repeat for all (Repeat for all four corners of the workstation) four corners of the workstation)
- Page 5 Kinked rail bars Kinked rail Remove the two bolts connecting the kinked rail to the end leg or intermediate Rotate the kinked rail to the required angle. (Repeat for both the front and rear leg. (Repeat for all four corners of the workstation) rail) Information about angles and heights is available towards the back of this document.
- Page 6 Kinked rail bars C-Clip Replace the two bolts connecting the kinked rail to the end leg or intermediate Rotate the C-Clip so that the hole faces upwards. (Repeat for the front and rear leg. (Repeat for all four corners of the workstation) rail)
- Page 7 Kinked rail brackets Top bolts Loosen the bolt that attaches the bracket to the rail. DO NOT remove the bolt. Ensure the top is straight. Then replace the bolts connecting the kinked rail (Repeat for all four corners of the workstation) bracket to the top.
- Page 8 Kinked rail brackets Tighten the bolt that attaches the bracket to the rail. (Repeat for all four corners of the workstation)
- Page 9 Bracket angles and height adjustments...
- Page 10 Standard Kinked Rail Kit (Rails and bracket) 0 Degrees When kinked rails are installed at 0 degrees the worktop height is 730mm from fl oor level 30 Degrees When kinked rails are installed at 30 degrees the worktop height is 755mm from fl...
- Page 11 Locations Knoll Benelux Knoll UK Knoll International SA Knoll International Ltd Tour & Taxis 91 Goswell Road Av.du Port 86 Havenlaan - C.215 Clerkenwell B-1000 Brussels, Belgium London tel. +32 (0)2 715 1300 EC1V 7EX fax +32 (0) 715 1319 United Kingdom benelux@knolleurope.com...
Need help?
Do you have a question about the Scope and is the answer not in the manual?
Questions and answers