Connect Faxfinder To Ethernet Network - Multitech FaxFinder FF-120 Administrator User Manual

2. Connect FaxFinder to Ethernet Network.

Plug one end of your RJ45 ethernet cable into the FaxFinder's ethernet jack and the other end into your
network ethernet hub. This ethernet cable is not included with your FaxFinder unit.
1 2 3
FF-420/820
Caution:
Before connecting to the Ethernet Network, make sure that the network to which you are
connecting the FaxFinder is not a 192.168.2.x subnet. Because the FaxFinder's factory default IP
address is 192.168.2.1, connecting it to a network that has a different device at that same IP address
would cause data interference.
If it is a 192.168.2.x subnet, connect from the Administrative PC to the FaxFinder using an RJ45
crossover cable until the FaxFinder's IP address has been configured. Thereafter, connect the
FaxFinder into the network with an ordinary RJ45 cable.
Multi-Tech Systems, Inc.
LAN 1
LINE 1 LINE 2
FF-120/220
4
5 6 7 8
ETHERNET
FF-120/220/420/820 FaxFinder Fax Server Admin User Guide
Chapter 3: Server Installation
Ethernet
Receptacle
CONSOLE
RESET
COMMAND
31