Preparations; Before Operation - Aiwa CX-N4000 U Operating Instructions Manual

BEFORE OPERATION
To turn on the unit+
Press the POWER button.
You can also turn the unit on by pressing one of the direct play
buttons. (See page 20.)
The disc compartment may open and close for resetting the unit.
After use
Press the POWER button to turn off the power. The display
changes to clock or DEMO mode.
After turning on the unit
The flash window above the disc compartment lights up.
For 4 seconds, the most recently used function button flashes in
green.
No operation maybe carried out during this 4-second period.
The flash window +
The flash window lights up during power on and flashes when the
disc compartment is opened or closed, and when the trays are
rotated.
To turn it off, operate as follows:
1 Turn on the power and press the CD button. (The CD button
lights in red.)
2 Press the button while pressing the CD button,
To turn it back on, repeat the procedure.
Do not carry out this operation during recording.
Illumination guide + E
Whenever one of the function buttons is pressed, the buttons for
that operation light up or flash.
Example:
When connecting the AC cord, the II SET button flashes to guide
you in setting the current time.
Headphones
Connect headphones to the PHONES jack with a stereo standard
plug (06.3 mm/l/, inch).
No sound is heard from the speakers while headphones are
plugged in.
After a power interruption
The current time needs to be reset. (See page 22.)
If power is interrupted for more than about 24 hours, you will also
have to reset preset stations and timer playback or recording
settings.