Recording Manually; Using Parking Mode - Thinkware QA200 User Manual

Using recording features
• Wait until the product is completely booted up after turning it on, and then begin operating the vehicle. The
video recording does not begin until the product is completely turned on (booted up).
• When incident continuous recording starts, a double "beep" sounds as a notification. This function saves
you time when checking the status LED to know the operating status of the product.
• To enable recording, you must insert a memory card into the product.

3.4 Recording manually

You can record a scene you want to capture while driving and store it as a separate file.
To start manual recording, press the REC (
guide. During manual recording, the product operates as follows.
Mode
Manual recording

3.5 Using parking mode

When the product is connected to the vehicle via the hardwiring cable, the operating mode is switched to
parking mode with the voice guide after the engine or electrical accessories are turned off.
• Parking mode operates only when the hardwiring cable is connected. The hardwiring cable must be
professionally installed to the vehicle by a trained mechanic.
• To use all recording modes, you must insert a memory card into the product.
• Depending on the battery charging status of the vehicle, the duration of parking mode may differ. If you
want to use parking mode for an extended period, check the battery level to prevent battery depletion.
If you do not want to use parking mode or you want to change the mode settings, from the mobile viewer,
tap Dash Cam Settings
18
When you press the REC (
1 minute, from 10 seconds before to 50 seconds after pressing the
button, and stored in the "manual_rec" folder.
Record Settings.
>
) button. Then, manual recording will start with the voice
Operation description
) button, a video will be recorded for
Recording LED (REC)
(flickers)