Installing The Rear Camera; Selecting An Installation Location; Securing The Rear Camera - Thinkware QA200 User Manual

2.2 Installing the rear camera

Refer to the following instructions to properly install the rear camera.

2.2.1 Selecting an installation location

• For vehicles with a sunshade attached to the rear windshield, you must select a location where using the
sunshade will not interfere with camera operation.
• The adhesive part of the rear camera should not touch the defrost grid.

2.2.2 Securing the rear camera

Refer to the following instructions to secure the product to the installation location.
1
After determining the installation location, wipe the installation surface of the windshield with a dry
cloth.
Check the installation location before you secure the rear camera to the rear windshield. After
securing the rear camera to the windshield, it is hard to remove the camera or change the installation
location due to the strong adhesive.
2
➋ ➋
2
Select a location on the rear windshield where there
is no defrost grid wire and the camera can record
the entire rear view.
Remove the protective film from the adhesive mount
and camera lens.
➊ ➊
1
Installing the product
15