Datamax S-Class ST-3210 Operator's Manual page 56

Print Engine
Maximum Fields and
Characters Per Ticket:
Tear Bar:
DRAM Memory:
Internal Module Size:
Scalable Module Size:
EPROM Memory:
Ticket Stock Requirements
Type:
Maximum Ticket Width:
Minimum Ticket Width:
Ticket Thickness Range:
(if Cutter option equipped):
Fanfold Ticket Length
(ST models only):
Fanfold Ticket Height
(ST models only):
Roll Capacity
(if Roll Hanger option
equipped):
[1]
The reflective TOF Mark must be black, carbon based, and placed on the backside of
the stock with a minimum size of .125 inch (3.175 mm) long (direction of travel) by
.5 inch (12.7 mm) wide, with the center falling between .235 inch (6 mm) and 3.03
inches (77 mm) from the edge while allowing adequate Quiet Zone space (see the
diagram in Section 6.1). The reflectance of the mark shall be less than 10% at
wavelengths of 950 and 640 nm.
46
(continued)
600 fields with 16,000 characters per ticket
Tear up/down
4 MB
512 KB (default)
256 KB (default)
1 MB
Fan-fold
reflective
3.25 inches (82.55 mm)
1.9 inches (48.2 mm)
.005 inch – .010 inch (.13 mm – .25 mm)
.025 inch – .008 inch (.06 mm – .2 mm)
11.375 inches (289 mm) maximum for interior
placement of the stock.
4.5 inches (114.3 mm) maximum for interior
placement of the stock.
7.0-inch (177.8 mm) maximum outer diameter
rolls of ticket stock wound with the TOF Marks
facing inward, on 2.0-inch (50.8 mm) diameter
cores.
and roll (if
[1]
direct thermal stock.
ST/SV-3210 and ST/SV-3306
option equipped)