Datamax S-Class ST-3210 Operator's Manual page 5

Agency Compliance and Approvals:
C US
Listed
FCC:
þ Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with
the instructions in this manual, it may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
UL1950 Information Technology Equipment
C22.2 No. 950-M93
EN60950
For 230 Volt Operation (Europe): Use a cord set, marked "HAR," consisting
of a min H05VV-F cord which has a minimum 0.75 square mm diameter
conductors, provided with an IEC 320 receptacle and a male plug for the
country of installation rated 6A, 250V
Für 230 Volt (Europa): Benützen Sie ein Kabel, das mit "HAR" markiert ist,
bestehend mindestens aus einem H05VV-F Kabel, das mindestens 0,75
Quadratmillimeter Drahtdurchmesser hat; sowie eine IEC320 Steckdose und
einen für das Land geeigneten Stecker, 6A, 250 Volt.
As an Energy Star Partner, the manufacturer has determined that this product
meets the Energy Star guidelines for energy efficiency.
The manufacturer declares under sole responsibility that this product conforms
to the following standards or other normative documents:
EMC: EN55022 (1993) Class B
EN50082-1 (1992)
EN61000-3-2 (1995)
EN61000-3-3 (1995)
IEC 801-2 (1991), 8kV CD; 15kV AD
IEC 801-3 (1984), 3 V/m
IEC 801-4 (1988),
EN 55024 (1998) SV Model Only
Safety: This product complies with the requirements of EN 60950/A11:1997
Gost-R
This device complies with FCC CFR 47 Part 15 Class A.
500V Signal Lines
1kV AC Power Lines